STREAMLIGHT 400157 LiteBox Replacement Switch with Boot

what our customer say this product:

Powered by

1. Danny hyde (Debner + Co) Verified Buyer – 6 August 2024

   You can go wrong with this one. Easy to install saves you a ton money from replacing the light.
   

2. Kenneth Masterenko Verified Buyer – 14 August 2024

   This is the absolute original part for the Stream Lite Light Box. Some soldering required unless you decide to use barrel crimp connectors.
   

3. John A. English, Jr. Verified Buyer – 13 September 2024

   Exact replacement switch. Easy installation.
   

4. Steven J Verified Buyer – 20 November 2024

   Remove the six bottom screws and takeoff the bottom, remove and disconnect the battery, slide out the circuitboard, gently pinch and pull off the little rubber boot on the outside of the switch, unscrew the white plastic ring and the switch comes right out, there’s no need to solder, cut the wires leaving plenty at the circuit board side, stripped the wires connect the new switch add a little tape or wire nut push the new switch up through the whole screw on the plastic ring pop on the rubber boot put everything back together and you’re done 10 minute job

   

5. Anonymous Verified Buyer – 2 February 2025

   Super Simple, tin the wires & just use tiny blue wire nuts
   

6. Big John Verified Buyer – 8 April 2025

   This product is the OEM factory part and perfect for restoring your litebox to original condition. It will either solder directly to the board or you can splice it in with crimp connectors. The crimp connectors do not come with the switch. A new rubber boot does come with the switch.
   

7. RN, FNP Verified Buyer – 9 May 2025

   Works like new. Requires sodering to board. The old switch was difficult to remove, required distruction with plyers.
   

8. Woodrow Devries Verified Buyer – 12 May 2025

   OEM Form Fit Function
   Installer, checks good.
   Switch plus a new battery…works good.
   

9. Todd Wood Verified Buyer – 12 June 2025

   Worked perfectly